TIDE 2.0
With HGM170 Control Module, the functions as below: |
 |
| As an option we also have DSE 702 (DEEP SEA) control module to be chosen: |
| |
| FEATURES锛 |
 |
Manual start
|
 |
|
Engine pre-heat |
|
Engine monitoring and protection features |
|
Protected solid state (PSS) outputs |
|
Front panel mounting |
|
Tamper proof engine hours counter |
|
Reomte start |
|
LED indicators |
|
| |
| BENEFITS |
|
Hours counter provides accurate information for monitoring maintenance and warranty periods. |
|
Multiple engine parameters are monitored simultaneously |
|
| |
| OVERSPEED PROTECTION |
The engine over speed trip setting can be calibrated at the rear of the module for 50Hz or 60Hz nominal operation (57Hz or 68Hz trip respectively).
During engine cranking and for the first 10 seconds after the engine starts running , all alarm conditions are suspended (overspeed is enabled) to allow the engine to reach its optimum running speed. |
| |
TIDE 3.0
With HGM6110 (Standard) control module |
Main Features |
HGM6110 |
Display |
LCD |
Language |
Chinese/English |
Hours |
鈼 |
Plug-pull terminal |
鈼 |
Com port |
Link |
Fix Input |
1 |
Config Input |
2 |
Fix output |
2 |
Config output |
4 |
Analog Input |
3 |
Generator Data |
鈼 |
Engine Data |
鈼 |
Fuel Level |
鈼 |
Over speed |
鈼 |
High engine temp. |
鈼 |
Low oil pressure |
鈼 |
Fail to start |
鈼 |
Over voltage |
鈼 |
Under voltage |
鈼 |
Over current |
鈼 |
Short circuit |
鈼 |
Idle control |
鈼 |
|
 |
 |
 |
| DSE7210 |
HGM6310 |
| TIDE 3.0 has HGM6310 and DSE7210 with RS232/RS485 com port for your option |
|
| For your reference, we also have TIDE4.0, TIDE 5.0 and TIDE6.0 to fulfill your different requirements. |
TIDE 4.0 with DSE 7310 Control module has the function of supervising.
TIDE 5.0 with DSE 7510 Control module mainly used in parallel operation, self synchronization, active and reactive power regulations.
TIDE 6.0 with DSE 7520 Control module is applicable to parallel with mains, add GSM function if it is necessary.
|
| |
| |
